How to Make Rage 808s in FL Studio (Distorted, Loud, Clean)

Rage beats live and die by the 808: loud, distorted, and still clear on small speakers. Here is a simple chain that works in stock FL Studio.

1. Start with the right 808

Pick an 808 that already has some grit and a short attack. A clean sine 808 needs much more distortion and gets muddy fast. Distorted packs like Black Tar 808s are built for this.

2. Tune it to the key

Load it in a Sampler or FL Studio's Slicex, find the root note and set the channel pitch so it plays in your song's key. Out-of-tune 808s are the number one reason rage beats sound off.

3. Distort in stages

• Fruity Soft Clipper first, for gentle saturation
• Then Distructor or Fruity Blood Overdrive for the aggressive layer
• Keep the mix knob under 70 % so the sub survives

4. Keep the sub mono and clean

After distortion, high-pass anything below 30 Hz and keep everything under 120 Hz in mono. Use a parallel clean sub if the low end disappears.

5. Glides

Rage 808s slide a lot. Use portamento in the channel settings or slide notes in the piano roll, and keep glides under one beat so the groove stays tight.

Skip the setup

The Rage Bundle includes 5 loud, distorted kits made for this sound, and our free drum kit is a quick way to try it.